MakeEverything
This is what a keyboards for!!!!
Find all posts
View Articles
View Blog EntriesMini Statistics
- Join Date
- 24-01-2010
- Last Activity
- Today 11:42 PM
- Blog Entries
- 32
- Avatar
More 2 Friends
Recent Visitors
This page has had 119 visits
About MakeEverything
Basic Information
About MakeEverything
- Location
- Stevenage
- 21TOC Member No.
- 298
Contact
Statistics
Total Posts
- Total Posts
- 307
- Posts Per Day
- 1.36
Total Thanks
- Total Thanks
- 2
- Thanked 0 Times in 0 Posts
Downloads
- Downloads
- 0
- Uploads
- 0
General Information
- Last Activity
- Today 11:42 PM
- Join Date
- 24-01-2010
- Referrals
- 0
View MakeEverything's Blog
21 Turbo Kit Car
by MakeEverything on Today at 01:34 PM
Made and welded up the VR sensor bracket today. Its fairly substantial, but rather that than too weak.
Missing tooth should be 9 teeth ahead of the sensor.
All done by 3pm, and
21 Turbo Kit Car
by MakeEverything on Yesterday at 10:39 PM
Thought i would tack the trigger wheel on tonight and see if it was in fact concentric. Im pleased to say it was!!
Took longer to get the TIG welder out, but at least its done now, and ready for fully welding and dressing.
I have the week off (Other than wednesday) so the objective of the week is to get the engine
21 Turbo Kit Car
by MakeEverything on 01-09-2010 at 07:45 PM
Thanks to Andy (again!) oh, and Dave for helping me identify the wrong timing belt that i was sold!!
More progress tonight; The trigger wheel.......
Sorry Andy! I was listening, but at least now i dont have to;
A) Get it machined
21 Turbo Kit Car
by MakeEverything on 01-09-2010 at 12:04 PM
Had a good start to the day. Managed to get the oil filter remote takeoff drilled and tapped to 20mm (19mm drill bit came today), and fitted to the car.
With barely enough room, even after grinding off the wrench stud.
This should be ok, as it i can use a strap wrench to remove it if i need to later on. Not sure if it
Brief Update & Plan
by MakeEverything on 30-08-2010 at 03:09 PM
Had a week off (Malta) last week, so ive had withdrawal symptoms from the project.
Made some progress today in that i have now permanently fixed the supercharger, and found a belt to fit it though it is a little slack and may need to be shorter.
Plan for next week is to get the engine trial fitted to the car and the mounts sorted out. Then start to make up the inlet hoses and exhaust, ready
